[Bug 12122] Error: failed to initialize HAL! Caused by HP ScanJet 4100C (USB)

[bugzilla-daemon at bugzilla.ubuntu.com]

Please do not reply to this email.  You can add comments at
http://bugzilla.ubuntu.com/show_bug.cgi?id=12122
Ubuntu | linux





------- Additional Comments From turnip at turnipspatch.com  2005-08-22 13:46 UTC -------
(In reply to comment #18)
> Yes, that would be helpful.  Try Colony 3:
> http://cdimage.ubuntu.com/releases/breezy/colony-3/

I have done.

Before, when I booted, the GNOME panel would fail to respond, then I'd get an
error message, then I'd have to wait, and then it would all finish loading up.

I also discovered if I wait between booting the computer and logging in (say, a
minute or so), then it works fine.

With Breezy, there was no error message, but the GNOME panel was still
unresponsive and still didn't load for a while. So I guess the message is gone
but the error still exists.

-- 
Configure bugmail: http://bugzilla.ubuntu.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are the QA contact for the bug, or are watching the QA contact.