[Bug 1877089] Re: zfcpdump kernel can not be IPLed when secure boot is requested

[Dimitri John Ledkov]

Thank you for those details.

For example, if and when we bump ubuntu minimum abi to z15 we might be
able to kill the zfcpdump kernel.

If there are no modules i guess any initrd will not be able to do much.

-- 
You received this bug notification because you are a member of Ubuntu
Foundations Bugs, which is subscribed to s390-tools in Ubuntu.
https://bugs.launchpad.net/bugs/1877089

Title:
  zfcpdump kernel can not be IPLed when secure boot is requested

Status in Ubuntu on IBM z Systems:
  Triaged
Status in s390-tools package in Ubuntu:
  Invalid
Status in zfcpdump-kernel package in Ubuntu:
  Confirmed
Status in zfcpdump-kernel source package in Focal:
  Confirmed
Status in zfcpdump-kernel source package in Groovy:
  Confirmed

Bug description:
  I installed Ubuntu 20.04 on IBM z15 with secure=1 in zipl conf.
  System can be secure booted, /sys/firmware/ipl/secure shows "1".
  I prepared zfcp dump disk as described in LTC bug 185713.
  Stopped the system and performed a SCSI dump with "Enable Secure Boot for Linux" enabled.

  Operating System Messages on HMC:
  Preparing system.
  Starting system.
  System version 8.
  Watchdog enabled.
  Running 'ZBootLoader' version '1.0.0' level 'D41C.D41C_0014'.
  ZBootLoader 2.1.0.
  MLOLOA6269064E Secure IPL: There are no signed components available on device HB
  A=0.0.1800, WWPN=500507630309D327, LUN=4046400900000000.
  IPL failed.

  Without "Enable Secure Boot for Linux" the dump kernel was IPLed and a
  dump created.

  Then I tried to rewrite the zfcp dump kernel with explicite setting of --secure=1:
  root at t35lp25:~# zipl --secure=1 -d /dev/disk/by-id/scsi-36005076303ffd3270000000000004609-part1
  Building bootmap directly on partition '/dev/disk/by-id/scsi-36005076303ffd3270000000000004609-part1'
  Adding dump section
    initial ramdisk...: /lib/s390-tools/zfcpdump/zfcpdump-initrd
    kernel image......: /lib/s390-tools/zfcpdump/zfcpdump-image
    kernel parmline...: 'root=/dev/ram0 dump_mem=1 possible_cpus=1 cgroup_disable=memory '
    component address:
      heap area.......: 0x00002000-0x00005fff
      stack area......: 0x0000f000-0x0000ffff
      internal loader.: 0x0000a000-0x0000dfff
      parameters......: 0x00009000-0x000091ff
      kernel image....: 0x00010000-0x001b9fff
      parmline........: 0x001ba000-0x001ba1ff
      initial ramdisk.: 0x001c0000-0x0020edff
  Preparing boot device: sde.
  Done.

  ...and tried to SCSI dump this device again. But the same  failure occured.
  Again, without "Enable Secure Boot for Linux" the dump kernel was IPLed and a dump created.

To manage notifications about this bug go to:
https://bugs.launchpad.net/ubuntu-z-systems/+bug/1877089/+subscriptions