[PATCH] klog: Add EC transaction failure detection

[Colin King]

From: Colin Ian King <colin.king at canonical.com>

Signed-off-by: Colin Ian King <colin.king at canonical.com>
---
 data/klog.json |    7 +++++++
 1 files changed, 7 insertions(+), 0 deletions(-)

diff --git a/data/klog.json b/data/klog.json
index 4598754..e1a9143 100644
--- a/data/klog.json
+++ b/data/klog.json
@@ -70,6 +70,13 @@
   {
    "compare_mode": "regex",
    "log_level": "LOG_LEVEL_HIGH",
+   "tag": "FWTS_TAG_EMBEDDED_CONTROLLER",
+   "pattern": "ACPI:.*EC.*input buffer is not empty, aborting transaction",
+   "advice": "The ACPI Embedded Controller (EC) driver attempted to perform a read or write transaction but had to abort because the EC was still busy and the input buffer was not emptied within 500ms.  Normally this indicates an EC firmware fault.  One can try increasing the delay using the acpi.ec_delay kernel parameter or writing to /sys/module/acpi/parameters/ec_delay - however this generally does not help much of the EC firmware is buggy."
+  },
+  {
+   "compare_mode": "regex",
+   "log_level": "LOG_LEVEL_HIGH",
    "tag": "FWTS_TAG_BIOS",
    "pattern": "ENERGY_PERF_BIAS.*Set to 'normal'.* was 'performance'",
    "advice": "The MSR_IA32_ENERGY_PERF_BIAS was initialized incorrectly and was defaulted to a high performance bias setting.  The kernel has detected this and changed it down to a 'normal' bias setting.  The BIOS vendor should be informed that the MSR is not defaulted to the normal bias setting."
-- 
1.7.9.1