[Bug 21803] pcmcia subsystem not functional with kernel 2.6.15-10 (ioremap failed)
bugzilla-daemon at bugzilla.ubuntu.com
bugzilla-daemon at bugzilla.ubuntu.com
Mon Jan 9 20:04:04 UTC 2006
Please do not reply to this email. You can add comments at
http://bugzilla.ubuntu.com/show_bug.cgi?id=21803
Ubuntu | linux
------- Additional Comments From eudoxos at arcig.cz 2006-01-09 20:04 UTC -------
Meanwhile, I tried PCMCIA IDE controller with CDROM, which worked without any
problem (except for the `pccardctl insert` necessity), it is set to operate in
PCMCIA (16bit) mode, not CardBus, though.
The aformentioned Ralink wifi card does not work with ndiswrapper either, as it
used to with 2.6.12. The device wlan0 appears but does not work (no connection).
Inserted when running lspci -vv:
falx:~# lspci -vv
0000:00:00.0 Host bridge: Intel Corporation 82440MX Host Bridge (rev 01)
Subsystem: Fujitsu Limited.: Unknown device 107f
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort+ >SERR- <PERR-
Latency: 64
0000:00:00.1 Multimedia audio controller: Intel Corporation 82440MX AC'97 Audio
Controller
Subsystem: Fujitsu Limited. QSound_SigmaTel Stac97 PCI Audio
Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 0
Interrupt: pin B routed to IRQ 9
Region 0: I/O ports at 1000 [size=256]
Region 1: I/O ports at 1400 [size=64]
0000:00:00.2 Modem: Intel Corporation 82440MX AC'97 Modem Controller (prog-if 00
[Generic])
Subsystem: Fujitsu Limited.: Unknown device 10d1
Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 0
Interrupt: pin B routed to IRQ 9
Region 0: I/O ports at 1800 [size=256]
Region 1: I/O ports at 1480 [size=128]
0000:00:07.0 Bridge: Intel Corporation 82440MX ISA Bridge (rev 01)
Control: I/O+ Mem+ BusMaster+ SpecCycle+ MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 0
0000:00:07.1 IDE interface: Intel Corporation 82440MX EIDE Controller (prog-if
80 [Master])
Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 64
Region 4: I/O ports at 1460 [size=16]
0000:00:07.2 USB Controller: Intel Corporation 82440MX USB Universal Host
Controller (prog-if 00 [UHCI])
Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 64
Interrupt: pin D routed to IRQ 15
Region 4: I/O ports at 1440 [size=32]
0000:00:07.3 Bridge: Intel Corporation 82440MX Power Management Controller
Control: I/O+ Mem+ BusMaster- SpecCycle+ MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
0000:00:12.0 Ethernet controller: Realtek Semiconductor Co., Ltd.
RTL-8139/8139C/8139C+ (rev 10)
Subsystem: Fujitsu Limited.: Unknown device 111c
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (8000ns min, 16000ns max)
Interrupt: pin A routed to IRQ 9
Region 0: I/O ports at 8000 [size=256]
Region 1: Memory at fc000000 (32-bit, non-prefetchable) [size=256]
Capabilities: [50] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=375mA
PME(D0-,D1+,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
0000:00:13.0 CardBus bridge: O2 Micro, Inc. OZ6933/711E1 CardBus/SmartCardBus
Controller (rev 02)
Subsystem: Fujitsu Limited.: Unknown device 10e6
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping+ SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 168
Interrupt: pin A routed to IRQ 9
Region 0: Memory at 18020000 (32-bit, non-prefetchable) [size=4K]
Bus: primary=00, secondary=01, subordinate=04, sec-latency=176
Memory window 0: 10000000-11fff000 (prefetchable)
Memory window 1: 12000000-13fff000
I/O window 0: 00001c00-00001cff
I/O window 1: 00002400-000024ff
BridgeCtl: Parity- SERR- ISA- VGA- MAbort- >Reset- 16bInt+ PostWrite+
16-bit legacy interface ports at 0001
0000:00:13.1 CardBus bridge: O2 Micro, Inc. OZ6933/711E1 CardBus/SmartCardBus
Controller (rev 02)
Subsystem: Fujitsu Limited.: Unknown device 10e6
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping+ SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 168
Interrupt: pin B routed to IRQ 9
Region 0: Memory at 18021000 (32-bit, non-prefetchable) [size=4K]
Bus: primary=00, secondary=05, subordinate=08, sec-latency=176
Memory window 0: 14000000-15fff000 (prefetchable)
Memory window 1: 16000000-17fff000
I/O window 0: 00002800-000028ff
I/O window 1: 00002c00-00002cff
BridgeCtl: Parity- SERR- ISA- VGA- MAbort- >Reset- 16bInt- PostWrite+
16-bit legacy interface ports at 0001
0000:00:14.0 VGA compatible controller: ATI Technologies Inc Rage Mobility P/M
(rev 64) (prog-if 00 [VGA])
Subsystem: Fujitsu Limited.: Unknown device 114f
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping+ SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 66 (2000ns min), Cache Line Size: 0x08 (32 bytes)
Interrupt: pin A routed to IRQ 9
Region 0: Memory at fd000000 (32-bit, non-prefetchable) [size=16M]
Region 1: I/O ports at 2000 [size=256]
Region 2: Memory at fc001000 (32-bit, non-prefetchable) [size=4K]
Expansion ROM at 18000000 [disabled] [size=128K]
Capabilities: [5c] Power Management version 1
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
0000:05:00.0 Network controller: RaLink Ralink RT2500 802.11 Cardbus Reference
Card (rev 01)
Subsystem: RaLink: Unknown device 2560
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 64
Interrupt: pin A routed to IRQ 9
Region 0: Memory at 16000000 (32-bit, non-prefetchable) [size=8K]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
This is a snip from dmidecode (useful?) for the PCMCIA slots:
Handle 0x0019
DMI type 9, 13 bytes.
System Slot Information
Designation: CardBus-1
Type: 32-bit PC Card (PCMCIA)
Current Usage: Unknown
Length: Other
ID: Adapter 0, Socket 0
Characteristics:
5.0 V is provided
3.3 V is provided
PC Card-16 is supported
Cardbus is supported
Modem ring resume is supported
PME signal is supported
Handle 0x001A
DMI type 9, 13 bytes.
System Slot Information
Designation: CardBus-2
Type: 32-bit PC Card (PCMCIA)
Current Usage: Unknown
Length: Other
ID: Adapter 1, Socket 0
Characteristics:
5.0 V is provided
3.3 V is provided
PC Card-16 is supported
Cardbus is supported
Modem ring resume is supported
PME signal is supported
--
Configure bugmail: http://bugzilla.ubuntu.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are the QA contact for the bug, or are watching the QA contact.
More information about the kernel-bugs
mailing list