[Bug 39862] Re: [sky2] Marvell ethernet interface doesn' t work after reboot

[Jyri Sillanpaa]

Etienne:

Somewhat strangely the sound card started working with the older kernel
when I used modprobe to install the snd_via82xx module, insmod gave
error about unknown symbol in the module (some kind of a problem with
new module-init-tools?) ... and then used alsamixer to remove the mutes
from Master and PCM.

Here is a dmesg, it seems that one of the cards (the one integrated to
the motherboar) uses skge and the one in PCI-slot sk98lin, go figure ...

[4294774.165000] sk98lin: Network Device Driver v8.23.1.3
[4294774.165000] (C)Copyright 1999-2005 Marvell(R).
[4294774.182000] ACPI: PCI Interrupt 0000:05:00.0[A] -> GSI 36 (level, low) -> IRQ 36
[4294774.199000] PCI: Setting latency timer of device 0000:05:00.0 to 64
[4294774.263000] eth1: Marvell Yukon 88E8053 Gigabit Ethernet Controller
[4294774.272000]       PrefPort:A  RlmtMode:Check Link State
[4294785.683000] eth1: network connection up using port A
[4294785.683000]     speed:           1000
[4294785.683000]     autonegotiation: yes
[4294785.683000]     duplex mode:     full
[4294785.683000]     flowctrl:        symmetric
[4294785.683000]     role:            slave
[4294785.683000]     irq moderation:  disabled
[4294785.683000]     tcp offload:     enabled
[4294785.683000]     scatter-gather:  enabled
[4294785.683000]     tx-checksum:     enabled
[4294785.683000]     rx-checksum:     enabled
[4294785.683000]     rx-polling:      enabled
[4294794.297000] eth1: no IPv6 routers present
[4294814.398000] skge eth0: enabling interface
[4294816.828000] skge eth0: Link is up at 1000 Mbps, full duplex, flow control tx and rx
[4294824.555000] eth0: no IPv6 routers present

I'll try the driver next week (important deadline on Friday and weekend
for the last fixes :-).

-- 
[sky2] Marvell ethernet interface doesn' t work after reboot
https://launchpad.net/bugs/39862