[Bug 45428] Re: Usb2 to ide storage device not working properly

[Xan]

When I attach the disk plugged into usb-ide cable, I get the following (dmesg):
[ 9865.244535] usb 2-3: new high speed USB device using ehci_hcd and address 3
[ 9865.378467] usb 2-3: configuration #1 chosen from 1 choice
[ 9865.381158] scsi7 : SCSI emulation for USB Mass Storage devices
[ 9865.381789] usb-storage: device found at 3
[ 9865.381792] usb-storage: waiting for device to settle before scanning
[ 9870.380392] usb-storage: device scan complete
[ 9870.383785] scsi 7:0:0:0: Direct-Access     Maxtor 6 Y120L0           0811 PQ: 0 ANSI: 0
[ 9870.388434] sd 7:0:0:0: [sdc] 240121728 512-byte hardware sectors: (122 GB/114 GiB)
[ 9870.409709] sd 7:0:0:0: [sdc] Test WP failed, assume Write Enabled
[ 9870.409719] sd 7:0:0:0: [sdc] Assuming drive cache: write through
[ 9870.410802] sd 7:0:0:0: [sdc] 240121728 512-byte hardware sectors: (122 GB/114 GiB)
[ 9870.415089] sd 7:0:0:0: [sdc] Test WP failed, assume Write Enabled
[ 9870.415099] sd 7:0:0:0: [sdc] Assuming drive cache: write through
[ 9870.415110]  sdc: unknown partition table
[ 9870.422657] sd 7:0:0:0: [sdc] Attached SCSI disk
[ 9870.422811] sd 7:0:0:0: Attached scsi generic sg3 type 0
[10182.285321] usb 2-3: USB disconnect, address 3

-- 
Usb2 to ide storage device not working properly
https://bugs.launchpad.net/bugs/45428
You received this bug notification because you are a member of Kernel
Bugs, which is a direct subscriber.