reseau en panne?
J Bond 0.07
jojonuxdelux at gmail.com
Sam 23 Fév 09:12:57 UTC 2008
J Bond 0.07 wrote:
>
Où est ce que je redirige le port 3128, sur le serveur, ou sur les
clents???? :
mon firewall dit :
# proxy transparent : regle de redirection vers le proxy
# on considere que eth0 est l'interface du reseau prive
# et que 3128 est le port du serveur proxy-cache
#${IPT} -t nat -A PREROUTING -p tcp -i eth2 --dport 80 -j REDIRECT
--to-port 3128
# Si la fonction passerelle est activee
if [ ${IN} ];
J Bond 0.07 wrote:
>> c.kumsta wrote:
>>> Perso, pour entrer des IP en fixe, je le fais directement dans le
>>> fichier "/etc/network/interfaces"
>>> Par exemple, dans ton cas :
>>> ========================================
>>> auto lo
>>> iface lo inet loopback
>>>
>>> auto eth0
>>> iface eth0 inet static
>>> address 192.168.0.4
>>> netmask 255.255.255.0
>>>
>>> auto eth2
>>> iface eth1 inet static
>>> address 192.168.88.1
>>> netmask 255.255.255.0
>>> ========================================
>>
>> Mon fichier interfaces :
>> This file describes the network interfaces available on your system
>> # and how to activate them. For more information, see interfaces(5).
>>
>> # The loopback network interface
>> auto lo eth2
>> iface lo inet loopback
>>
>> # This is a list of hotpluggable network interfaces.
>> # They will be activated automatically by the hotplug subsystem.
>> mapping hotplug
>> script grep
>> map eth2
>>
>> # The primary network interface
>>
>> iface eth2 inet static
>> address 192.168.88.1
>> netmask 255.255.255.0
>> gateway 192.168.1.4
>>
>>
>>
>>
>> auto dsl-provider
>> iface dsl-provider inet ppp
>> pre-up /sbin/ifconfig eth2 up # line maintained by pppoeconf
>> provider dsl-provider
>>
>> auto eth0:avah
>> iface eth0:avah inet manual
>>
>> #auto eth1
>>
>>
>> #auto eth0
>>
>>
>> #auto eth2
>>
>>
>> #auto eth2
>>
>> iface eth1 inet static
>> address 192.168.1.4
>> netmask 255.255.255.0
>> gateway 192.168.1.1
>>
>> auto eth1
>>
>> iface eth0 inet static
>> address 192.168.1.4
>> netmask 255.255.255.0
>> gateway 192.168.0.50
>>
>> auto eth0
>>>
>>> (à mon avis, ce n'est pas la peine de rajouter de champs "gateway"
>>> étant donné que c'est ta connexion vers ton FAI
>>> qui va le régler au moment de la négociation avec ton FAI sur ppp0)
>>>
>>> ++dune2
>>>
>>> Jmb at moustique:~$ sudo ifconfig
>> eth0 Lien encap:Ethernet HWaddr 00:13:8F:7A:C6:DD
>> inet adr:192.168.1.4 Bcast:192.168.1.255 Masque:255.255.255.0
>> UP BROADCAST MULTICAST MTU:1500 Metric:1
>> Packets reçus:0 erreurs:0 :0 overruns:0 frame:0
>> TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>> collisions:0 lg file transmission:1000
>> Octets reçus:0 (0.0 b) Octets transmis:0 (0.0 b)
>> Interruption:16 Adresse de base:0xc000
>>
>> eth1 Lien encap:Ethernet HWaddr 00:18:E7:07:F9:F4
>> inet adr:192.168.1.4 Bcast:192.168.1.255 Masque:255.255.255.0
>> adr inet6: fe80::218:e7ff:fe07:f9f4/64 Scope:Lien
>> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
>> Packets reçus:45 erreurs:0 :0 overruns:0 frame:0
>> TX packets:7 errors:0 dropped:0 overruns:0 carrier:0
>> collisions:0 lg file transmission:1000
>> Octets reçus:11692 (11.4 KB) Octets transmis:528 (528.0 b)
>> Interruption:19 Adresse de base:0x2800
>>
>> eth2 Lien encap:Ethernet HWaddr 00:10:A7:0C:8B:55
>> inet adr:192.168.88.1 Bcast:192.168.88.255
>> Masque:255.255.255.0
>> adr inet6: fe80::210:a7ff:fe0c:8b55/64 Scope:Lien
>> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
>> Packets reçus:4653 erreurs:0 :0 overruns:0 frame:0
>> TX packets:4201 errors:0 dropped:0 overruns:0 carrier:0
>> collisions:0 lg file transmission:1000
>> Octets reçus:3285428 (3.1 MB) Octets transmis:465510 (454.5 KB)
>> Interruption:20 Adresse de base:0xec00
>>
>> lo Lien encap:Boucle locale
>> inet adr:127.0.0.1 Masque:255.0.0.0
>> adr inet6: ::1/128 Scope:Hôte
>> UP LOOPBACK RUNNING MTU:16436 Metric:1
>> Packets reçus:408 erreurs:0 :0 overruns:0 frame:0
>> TX packets:408 errors:0 dropped:0 overruns:0 carrier:0
>> collisions:0 lg file transmission:0
>> Octets reçus:33437 (32.6 KB) Octets transmis:33437 (32.6 KB)
>>
>> ppp0 Lien encap:Protocole Point-à-Point
>> inet adr:194.206.79.171 P-t-P:195.146.243.10
>> Masque:255.255.255.255
>> UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1492 Metric:1
>> Packets reçus:4345 erreurs:0 :0 overruns:0 frame:0
>> TX packets:3825 errors:0 dropped:0 overruns:0 carrier:0
>> collisions:0 lg file transmission:3
>> Octets reçus:3171290 (3.0 MB) Octets transmis:357454 (349.0 KB)
>>
>> mb at moustique:~$
>>
>> ufconfig est bon, maintenant!
>> mb at moustique:~$ sudo route
>> Table de routage IP du noyau
>> Destination Passerelle Genmask Indic Metric Ref
>> Use Iface
>> lns2.l0.10.143. * 255.255.255.255 UH 0 0
>> 0 ppp0
>> 192.168.1.0 * 255.255.255.0 U 0 0
>> 0 eth0
>> 192.168.1.0 * 255.255.255.0 U 0 0
>> 0 eth1
>> 192.168.88.0 * 255.255.255.0 U 0 0
>> 0 eth2
>> link-local * 255.255.0.0 U 1000 0
>> 0 eth1
>> default * 0.0.0.0 U 0 0
>> 0 ppp0
>> mb at moustique:~$
>>
>> ça devrait marcher et ça marche pas : les ping sont perdus.
>>
>> Je regarde maintenant du coté des hosts et hosts.allow! :
>>
>> hosts:
>> 127.0.0.1 localhost
>> #
>> # The following lines are desirable for IPv6 capable hosts
>> ::1 ip6-localhost ip6-loopback
>> fe00::0 ip6-localnet
>> ff00::0 ip6-mcastprefix
>> ff02::1 ip6-allnodes
>> ff02::2 ip6-allrouters
>> ff02::3 ip6-allhosts
>> 192.168.88.3 violette
>> 192.168.1.1 modem
>> 192.168.0.50 dlink
>> 192.168.88.5 lombric
>> 192.168.1.4 crapaud.chikungugna.org
>>
>> hosts.allow :
>> /etc/hosts.allow: list of hosts that are allowed to access the system.
>> # See the manual pages hosts_access(5) and
>> hosts_options(5).
>> #
>> # Example: ALL: LOCAL @some_netgroup
>> # ALL: .foobar.edu EXCEPT terminalserver.foobar.edu
>> #
>> # If you're going to protect the portmapper use the name "portmap" for
>> the
>> # daemon name. Remember that you can only use the keyword "ALL" and IP
>> # addresses (NOT host or domain names) for the portmapper, as well as for
>> # rpc.mountd (the NFS mount daemon). See portmap(8) and rpc.mountd(8)
>> # for further information.
>> #
>> 192.168.88.3 violette
>> 192.168.88.5 lombric
>> 192.168.1.1 modem
>> 192.168.0.50 dlink
>> ALL: LOCAL @chikungugna.org
>> 192.168.1.4 crapaud.chikungugna.org
>>
>> Où est l'erreur? : ça devient compliqué, et le tuto n'est peut etre
>> pas trop clair..
>>
>>
> Feb 23 08:59:52 moustique dhcpd: All rights reserved.
> Feb 23 08:59:52 moustique dhcpd: For info, please visit
> http://www.isc.org/sw/dhcp/
> Feb 23 08:59:52 moustique dhcpd: Wrote 0 leases to leases file.
> Feb 23 08:59:52 moustique dhcpd:
> Feb 23 08:59:52 moustique dhcpd: No subnet declaration for eth1
> (192.168.1.4).
> Feb 23 08:59:52 moustique dhcpd: ** Ignoring requests on eth1. If this
> is not what
> Feb 23 08:59:52 moustique dhcpd: you want, please write a subnet
> declaration
> Feb 23 08:59:52 moustique dhcpd: in your dhcpd.conf file for the
> network segment
> Feb 23 08:59:52 moustique dhcpd: to which interface eth1 is attached. **
> Feb 23 08:59:52 moustique dhcpd:
> Feb 23 08:59:52 moustique dhcpd:
> Feb 23 08:59:52 moustique dhcpd: No subnet declaration for eth0
> (192.168.1.4).
> Feb 23 08:59:52 moustique dhcpd: ** Ignoring requests on eth0. If this
> is not what
> Feb 23 08:59:52 moustique dhcpd: you want, please write a subnet
> declaration
> Feb 23 08:59:52 moustique dhcpd: in your dhcpd.conf file for the
> network segment
> Feb 23 08:59:52 moustique dhcpd: to which interface eth0 is attached. **
> Feb 23 08:59:52 moustique dhcpd:
> Feb 23 08:59:52 moustique dhcpd: Can't bind to dhcp address: Address
> already in use
> Feb 23 08:59:52 moustique dhcpd: Please make sure there is no other dhcp
> server
> Feb 23 08:59:52 moustique dhcpd: running and that there's no entry for
> dhcp or
> Feb 23 08:59:52 moustique dhcpd: bootp in /etc/inetd.conf. Also make
> sure you
> Feb 23 08:59:52 moustique dhcpd: are not running HP JetAdmin software,
> which
> Feb 23 08:59:52 moustique dhcpd: includes a bootp server.
> Feb 23 08:59:52 moustique avahi-daemon[7568]: Server startup complete.
> Host name is moustique.local. Local service cookie is 3633587936.
> Feb 23 09:00:20 moustique hald: mounted /dev/sdc1 on behalf of uid 1000
> Feb 23 09:00:21 moustique hcid[7610]: Default passkey agent (:1.20,
> /org/bluez/passkey) registered
> Feb 23 09:00:21 moustique hcid[7610]: Default authorization agent
> (:1.20, /org/bluez/auth) registered
> Feb 23 09:00:23 moustique NetworkManager: <info> Updating allowed
> wireless network lists.
> Feb 23 09:00:23 moustique NetworkManager: <WARN>
> nm_dbus_get_networks_cb(): error received:
> org.freedesktop.NetworkManagerInfo.NoNetworks - There are no wireless
> networks stored..
> Feb 23 09:04:07 moustique ntpd[7539]: synchronized to 91.189.94.4,
> stratum 2
> Feb 23 09:04:07 moustique ntpd[7539]: time reset -0.509176 s
> Feb 23 09:04:07 moustique ntpd[7539]: kernel time sync status change 0001
> Feb 23 09:09:48 moustique ntpd[7539]: synchronized to 91.189.94.4,
> stratum 2
>
Plus d'informations sur la liste de diffusion ubuntu-fr