wifi stopped working, network manager glitch?
Adam Ghandoura
aghfreeman at gmail.com
Sat Dec 18 09:39:29 UTC 2010
Hi,
Are you sure your wifi switch is On, i had the same problem if i boot with
the switch OFF.
marf.
2010/12/17 ANDY <sirald66 at gmail.com>
> DELL LATITUDE D600
> BROADCOM BCM4306 802.11b/g
> UBUNTU 9.10 +proposed
>
>
> My wifi has been working months and months, but just stopped.
>
> * I think I unchecked Enable Wireless from the Gnome Panel Network Manager
> drop-down. [it is a known problem up to Ubuntu 9.10 that once the Enable
> Wireless is disabled either manually or by hibernate/sleep system modes,
> that it can not be re-enabled during the same session until the system has
> been restarted]
>
> * Restarted the system, it started asking for my wifi passphrase (which is
> still stored) and eventually it didn't see any local APs at all (of which
> there are many). The pull down says the BROADCOM is Disconnected (not
> disabled).
>
> * A borrowed USB wifi stick (RALINK 802.11 BG WLAN) which worked and used
> the stored AP passphrase.
>
> * Checked the Hardware Drivers which showed BROADCOM B43 WIRELESS DRIVER as
> Active. Removed/reinstalled it again as Active.
>
> * The Power Management field from iwconfig says off, and maybe should say
> 'managed'. I tried 'iwconfig wlan0 up', but that is an unrecognized
> command/feature.
>
> * I noticed when I used the borrowed USB wifi stick, the Network Manager
> does not ask for my admin password as it did for the built-in wifi. I just
> used the stored AP passphrase and connects.
>
>
> andy at TOBY:~$ dmesg | egrep 'b43|wlan0'
> [ 1.846981] b43-pci-bridge 0000:02:03.0: PCI INT A -> Link[LNKB] -> GSI
> 5 (level, low) -> IRQ 5
> [ 26.904262] b43-phy0: Broadcom 4306 WLAN found (core revision 5)
> [ 28.276150] b43 ssb0:0: firmware: requesting b43/ucode5.fw
> [ 28.280299] b43 ssb0:0: firmware: requesting b43/pcm5.fw
> [ 28.287597] b43 ssb0:0: firmware: requesting b43/b0g0initvals5.fw
> [ 28.295592] b43 ssb0:0: firmware: requesting b43/b0g0bsinitvals5.fw
> [ 28.424237] b43-phy0: Loading firmware version 410.2160 (2007-05-26
> 15:32:10)
> [ 28.500714] Registered led device: b43-phy0::tx
> [ 28.500740] Registered led device: b43-phy0::rx
> [ 28.500766] Registered led device: b43-phy0::radio
> [ 28.501296] ADDRCONF(NETDEV_UP): wlan0: link is not ready
> andy at TOBY:~$
>
>
> andy at TOBY:~$ iwconfig
> [snip]
> wmaster0 no wireless extensions.
> wlan0 IEEE 802.11bg ESSID:""
> Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated
> Tx-Power=20 dBm
> Retry long limit:7 RTS thr:off Fragment thr:off
> Power Management:off
> Link Quality:0 Signal level:0 Noise level:0
> Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
> Tx excessive retries:0 Invalid misc:0 Missed beacon:0
> andy at TOBY:~$
>
>
>
>
> ANDY - Salt Lake, UT US
>
>
> --
> ubuntu-users mailing list
> ubuntu-users at lists.ubuntu.com
> Modify settings or unsubscribe at:
> https://lists.ubuntu.com/mailman/listinfo/ubuntu-users
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.ubuntu.com/archives/ubuntu-users/attachments/20101218/e4037808/attachment.html>
More information about the ubuntu-users
mailing list