probe router wirelessly, double NAT

[Nils Kassube]

thufir wrote:
> On Sun, 29 Dec 2013 10:06:56 +0000, Colin Law wrote:
> >> Is the above a correct understanding?
> > 
> > No, a bridge is effectively a transparent device on the network
> > joining the two parts together.  The Cisco gateway is (from what
> > you describe) giving out addresses in the 192.168.0.x range and
> > they get passed straight through the bridge without modification. 
> > To probe the router just use 192.168.0.1 whichever side of he
> > bridge you are.
> 
> It's not possible that the router gives out an address in the
> 192.168.1.x range?  This device, the bridge I'm using, **always**
> gives out an address in the 192.168.0.x range when connecting to it.

Like Colin wrote already, the bridge is transparent for the netowrk. You 
get the IP address from the router, not from the bridge. Your initial 
post showed at the traceroute output that your router is at 192.168.0.1:

| 1  192.168.0.1 (192.168.0.1)  1.364 ms  6.244 ms  6.238 ms

If you want to connect to your router you should use 192.168.0.1 and not 
192.168.1.1.

> (The exception being that during configuration it's different.)

Yes, the configuration is different as it uses static addresses 
according to the manual. But after you have finished the configuration, 
the GWU works in bridge mode and you get your address from the router 
via DHCP.


Nils